WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL H. ENGINE BRAKE ENABLE AND PRESELECT REQUEST PLUS ENGINE BRAKE ENABLE OUTPUT USING EXHAUST BRAKES USES: Used with engine brakes to signal the ECU that the brake is active and to provide increased braking by preselecting a lower range. Also prevents engagement of engine brake with throttle > 0 or lockup OFF. VARIABLES TO SPECIFY: Preselect range. Standard value is second range. VOCATIONS: Various * NOTE: This switch is part of the engine brake system and provides an indication when the engine is at closed throttle. This switch, or an equivalent control feature, is REQUIRED for all installations. SWITCHED POWER V ** NOTE:
The engine brake must provide a low engine speed shutoff feature, set to disable the brake at a speed slightly higher than idle rpm. V-3 WIRE 132 ENGINE BRAKE ENABLE OUPUT ENGINE BRAKE DASH SWITCH NOTE: If the engine brake is an inductive load, it must be diode suppressed. OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) ENGINE THROTTLE SWITCH * ECU NC S-11 WIRE 119 ENGINE BRAKE AND PRESELECT REQUEST COM ENGINE BRAKE ** NO D2 S DASH LIGHT VIM Relay shown de-energized V04864 Figure P–10. Engine Brake Enable And Preselect Request Plus Engine Brake Enable Output Using Exhaust Brakes P–10 Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING!
These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. B1 BR O AKE N