WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL H. ENGINE BRAKE ENABLE AND PRESELECT REQUEST PLUS ENGINE BRAKE ENABLE OUTPUT USING ECM CONTROLLED EXHAUST BRAKES USES: Used with exhaust brakes controlled by electronic engines to signal the ECU that the brake is active and to provide increased braking by preselecting a lower range. Also prevents engagement of engine brake with throttle > 0 or lockup OFF. VARIABLES TO SPECIFY: Preselect range. Standard value is second range. VOCATIONS: Various SWITCHED POWER ** See Engine Schematic for pin locations.
CUSTOMER-FURNISHED ECM NC Relay shown de-energized ** ENGINE BRAKE DASH SWITCH COM NO EXHAUST BRAKE HIGH SIDE DRIVER MAXIMUM CURRENT PER ENGINE MANUFACTURER V V-3 WIRE 132 ENGINE BRAKE ENABLE OUPUT D2 ECU OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) ENGINE BRAKE SOLENOID* NO NC DASH LIGHT (Optional) B1 E2 COM SWITCHED POWER S S-11 WIRE 119 ENGINE BRAKE AND PRESELECT REQUEST VIM * NOTE: If the engine brake solenoid is an inductive load, it must be diode suppressed. Relay shown de-energized V07115 Figure P–11. Engine Brake Enable And Preselect Request Plus Engine Brake Enable Output Using ECM Controlled Exhaust Brakes Copyright © 2001 General Motors Corp.
P–11 APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. BR O AKE N