Industrial — APPENDIX P — INPUT/OUTPUT FUNCTIONS

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL O. AUTOMATIC NEUTRAL USES: Automatically shifts transmission to NEUTRAL when vehicle doors are opened. Re-engages transmission in DRIVE when doors are closed. VARIABLES TO SPECIFY: None VOCATIONS: Transit Buses SWITCHED POWER DOOR CONTROL SWITCH Switch is closed when either front or rear doors are opened V V-13 WIRE 118 AUTOMATIC NEUTRAL Switch indicates actual position of the door control lever ECU OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) TO DOOR CONTROLS NOTE: Use of this function requires review by Allison Engineering. S NOTE:

When transmission has been automatically shifted to NEUTRAL with this feature, DRIVE can be re-selected by either advancing the throttle or by selecting DRIVE at the shift selector. V07119 Figure P–20. Automatic Neutral P–20 Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life.

ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. WARNING! If this function is enabled in the shift calibration, the function MUST be integrated into the vehicle wiring. If the function is available in the shift calibration but will not be used in the vehicle, it MUST be disabled in the calibration. This function must not be used with Neutral Indicator For PTO (Output “S”).