WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL V. REVERSE ENABLE SWITCHED TO GROUND USES: Provides for a separate instrument panel-mounted switch which must be pressed simultaneously with the REVERSE button to achieve Reverse. VARIABLES TO SPECIFY: None VOCATIONS: European transit buses and tour buses SEE TABLE A TABLE A OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) OPTION 1 OPTION 2 V V-31 MOMENTARY SWITCH ECU SEE TABLE A REVERSE ENABLE S WIRE 161 SIGNAL RETURN V04876.01 Figure P–22. Reverse Enable Switched to Ground P–22 Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! WARNING!
These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which ddiiffffeerrss ffrroomm t thhaatt s hshoowwnn c ocouuldld c arues ue lut ninin dteanmdaegde s etole ecqtiuoinp omf ernatn ogre po r ooptheretry u, npper seodnicatla ibnljeu orpy,e roart il onss r oesf ullitfien. gA iLnL dIaSmOaNg eT tRo AeqNuSipMmISenStI OorN p rISop NerOtyT, LpeIrAsBonLaEl iFnOjuRry ,T oHrE lo CssO oNf SliEfeQ. AULELNICSEOSN A TSRSAONCSIAMTIESSDI OWNI TISH NMOITS WLIIARBINLGE OFORR U NTIHNTEE NCDOENDS EUQSEU EONFC TEHSE SAES SFOEACTIAUTREEDS . WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. WARNING!
If this function is enabled in the shift calibration, the function MUST be integrated into the vehicle wiring. If the function is available in the shift calibration but will not be used in the vehicle, it MUST be disabled in the calibration. PIN V-30 WIRE 117 PIN V-14 WIRE 177