Industrial — CODE 24 XX — SUMP FLUID TEMPERATURE

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 24 XX — SUMP FLUID TEMPERATURE (Figure 6–7) DIAGNOSTIC CODES Code 24 23: 1. Install temperature gauges for transmission temperature and engine water temperature. Drive the vehicle. Verify that the code can be reproduced and verify the reading shown on the diagnostic tool. Observe the gauges and check for hot fluid when the code is produced. 2. If the fluid is not hot when the code is produced, remove the transmission “T” harness connector at the ECU and the transmission. Check the fluid temperature sensor wiring for opens, shorts, and shorts-to-ground.

Compare the resistance readings of the sensor and the actual temperature as shown on the gauge with Figure 6–8 for TID 1 thermistors and Appendix Q for TID 2 thermistors. If wiring problems or a great difference between temperature and resistance compared with the chart are found, drain the fluid, remove the control module, and replace the temperature sensor (refer to the Service Manual for the transmission being checked). If wiring problems are found, repair or replace as necessary. 3. If the fluid is hot when the code is produced, observe the gauges to see if the engine became hot before the transmission.

If the engine cooling system is overheating and heating the transmission, the problem is with the engine or its cooling system. 4. If the transmission became hot before the engine, allow the vehicle to idle for 3–5 minutes and check the transmission fluid level. Correct the fluid level if necessary. 5. Attach pressure gauges to the cooling system (from a “to cooler” connection to a point after the cooling circuit filter) and check for pressure drop problems. If pressure drop is excessive (refer to Table 6–5), check for a plugged cooler filter, collapsed lines, obstructions, etc. 6.

If the fluid level is correct and the cooling circuits satisfactory, drain the fluid, remove the control module, and inspect for damaged valve body gaskets. Replace any damaged gaskets (refer to the appropriate transmission Service Manual). 7. If no problems are found in the control module area, remove the transmission and disassemble, in- specting for causes of overheating (stuck stator, plugged orifices, dragging clutches, etc.). (See the Service Manual for the transmission being checked.) Table 6–5. External Hydraulic Circuit Characteristics Basic, PTO, 93˚C (200˚F) Sump Temperature HD/B 500 Copyright © 2001 General Motors Corp.

6–41 CONVERTER OPERATION MAXIMUM COOLER FLOW AT MINIMUM PRESSURE DROP CONVERTER OPERATION COOLER FLOW AT MAXIMUM ALLOWABLE PRESSURE DROP Input rpm Flow Pressure Drop Input rpm Flow Pressure Drop L/s gpm kPa psi L/s gpm kPa psi 600 0.22 3.4 0 0 600 0.20 3.2 31 4.5 900 0.38 6.1 0 0 900 0.37 5.8 63 9.1 1200 0.55 8.7 0 0 1200 0.55 8.7 108 15.7 1500 0.80 12.7 0 0 1500 0.77 12.2 167 24.2 1800 1.03 16.4 0 0 1800 0.92 14.5 213 30.9 2100 1.13 18.0 0 0 2100 0.97 15.3 238 34.5 2300 1.20 19.0 0 0 2300 1.00 15.9 250 36.3