Frame and Frame Components 31 31–03 Frame Fastener Torque Check vehicle vehicle Workshop Manual for repair or re- placement information. Frame brackets and components secured with Huck- bolt® fasteners do not require a torque check, how- ever, they should be inspected for damage. Frame brackets and components secured with conventional bolts and nuts are to be checked at Initial Mainte- nance (IM). Check the torque of frame fasteners to offset the effects of "bedding in" (or seating). When checking torque, torque the nut, not the bolt head whenever possible. This will give a true torque read- ing by eliminating bolt-body friction.
When checking the torque of frame fasteners, inspect the frame for cracks and other damage. Set a click-type torque wrench to the maximum torque of the fastener you are checking. Apply pressure until the torque wrench clicks. Do not loosen the bolt to check the torque. Refer to Group 00 of the vehicle Workshop Manual for torque specifications. 31–04 Trailer Electrical Connector Lubricating In some cases, failure of trailer cables occurs due to intrusion of chloride-based road deicing chemicals into the trailer connector. Once inside the connector, the chloride-based chemicals corrode the brass ter- minals and create bridging between positive and ground terminals. NOTE:
The use of soap is not recommended for cleaning the electrical connector, as some soaps may increase the corrosion process. 1. Wash out any existing grease, dirt, and corrosion on the trailer connectors with electrical contact cleaner spray. NOTICE 2. Grease the trailer connector with a lithium-based dielectric grease. Make sure frame fasteners are properly tightened. Continued vehicle operation with loose fasteners could result in bracket or frame damage. 31–05 Premier 690 Coupling Inspection Check the fasteners at the following locations: Axle Stops IMPORTANT:
Before servicing the Premier cou- pling, refer to the Premier web site at www.premier-mfg.com for complete safety, operation, and maintenance instructions. Deck Plates Equalizer Brackets Exhaust Brackets Fifth Wheel Legs WARNING Fifth Wheel Mountings If at any time the 690 coupling is bound up (jack- knifed), the 294 bolt MUST be replaced immedi- ately! Do not use the coupling until the bolt has been replaced. In addition, carefully inspect the 690 coupling, drawbar, drawbar eye, front end as- sembly, and tail board for damage. Failure to do so may result in trailer separation from the truck while in use, resulting in serious personal injury or property damage.
Frame Crossmembers and Gussets Front Frame Brackets Front Suspension Spring Brackets Fuel Tank Brackets Radius Rods Rear Suspension Spring Brackets The time-in-service of the 294 bolt located in the 690 coupling must be monitored, and maintenance per- formed as follows. See Fig. 11 . Shock Absorbers All Other Frame Fasteners Any component that shows signs of cracking or other damage must be repaired or replaced. Refer to the For a new or replaced 294 bolt: 6 months after installation date: Record the date of installation. 122SD and Coronado 132 Maintenance Manual, February 2016 31/8