MAINTENANCE SERVICE PROCEDURE 6. If small holes or thinner parts are found on the element when it is checked by shining a light through it after cleaning, replace the element. NOTICE When cleaning the element, do not hit or beat it against anything. Do not use an element whose folds or gasket or seal are damaged. 7. Set the cleaned outer element and install dust cup(3), then secure them with clips(2). CAUTION When installing the dust cup, check O-ring(7). If the O-ring has any defect, replace it. 8. Return the red piston in the dust indicator(1) to its original position. 9. Close the left engine side cover. REPLACING ELEMENT 1. Open the left engine side cover. 2.
Remove four clips(2) to remove dust cup(3). 3. Remove outer element(4). Do not remove inner element(5) at this time, however. 4-21