Komatsu — PROCEDURE FOR BLEEDING AIR OF HYDRAULIC SYSTEM

SERVICE PROCEDURE MAINTENANCE REPLACEMENT G Container of 4 liters or larger to receive drained oil G Quantity of replacement oil: 1.3 liters (0.34 US gal) 1. Remove oil level plug(3) and oil filler plug(4), then remove drain plug 5 to drain the oil. After the all oil is drained, tighten plug(5). 2. Add engine oil through the hole of oil filler plug(4) until the oil level reaches the bottom edge of the hole of oil level plug(3). 3. After refilling the oil, tighten plugs(3) and (4). PROCEDURE FOR BLEEDING AIR OF HYDRAULIC SYSTEM See "STARTING ENGINE (PAGE 3-54)". Since the engine must be started and the blade must be operated, see the volume of operation.

NOTICE If the engine is run immediately at high speed or the cylinder is operated to the end of its stroke, the air inside the cylinder may cause damage to the piston packing. 1. Bleeding air from cylinders 1) Run the engine at low idling, and extend and retract each cylinder 4 - 5 times. Do not operate the cylin- der to the end of its stroke. (Stop at a point approx. 100 mm before the end of the stroke.) 2) Next, operate each cylinder 3 to 4 times to the end of its stroke. 3) Finally, operate each cylinder 4 to 5 times to the end of its stroke to completely remove the air. 4-38