178 Torque guide values Tightening the cylinder-head bolts following a repair (engine cold) Intake side Before inserting the cylinder head bolts, apply en- gine oil to the threads (not the tapped holes) and “Optimoly White T” installation past to the bolt 6 head contact faces. Do not use oils or oil additives containing MoS . The bolts are to be tightened 2 using the rotation angle method according to tigh- tening schedule as follows. 1 4 D 1st pretightening = to 10 Nm D 2nd pretightening = to 80 Nm D 3rd pretightening = to 150 Nm D 4th pretightening = 90° D Final tightening = 90° Set the valve clearance. 3 2 5 Exhaust side Tightening schedule Note:
When the head has been removed, the cylinder head gasket must always be replaced. Retightening the cylinder-head bolts following a repair (Engine cold or warm) After the first 10 to 20 hours of operation, following a repair, retighten the cylinder-head bolts in the order specified in tightening schedule by 90° (1/4 turn). The cylinder-head bolts to be retightened must not be loosened; they are to be tightened further from their current position by 90° (1/4 turn). Attach the sticker “First retightening of cylinder-head bolts ...” (remove sticker that might already be attached).
After the first 400 hours of operation, following a repair, tighten cylinder-head bolts 1 to 6 in the order specified in tightening schedule by another 90° (1/4 turn). Attach sticker “Second retightening of cylinder-head bolts ...”. Note: When the head has been removed, the cylinder head gasket must always be replaced.