180 Torque guide values Tightening the cylinder-head bolts following a repair (engine cold) Intake side Before inserting the cylinder head bolts, apply en- gine oil to the threads (not the tapped holes) and 6 “Optimoly White T” installation past to the bolt head contact faces. Do not use oils or oil additives containing MoS . The bolts must be tightened 2 using the torque angle method according to the 1 4 tightening sequence on the left. D 1st pretightening = to 10 Nm D 2nd pretightening = to 80 Nm D 3rd pretightening = to 150 Nm D 4th pretightening = 90° D Final tightening = 90° Set the valve clearance.
Following successful first tightening during a repair, remove the existing sticker from the valve cap. 3 2 5 Exhaust side Note: When the head has been removed, the cylinder head gasket must always be replaced. Note: When the head has been removed, the cylinder head gasket must always be replaced.