Removing and Installing / Repairing Oil Pump Checking the axial clearance of the pump wheels Fig. 9 Attach a dial gauge, push the shaft in one direction up to the stop and set the dial gauge to “0”. Press the shaft in the opposite direction and read off the reaction of the dial gauge. Axial clearance of pump gears in new condition see “Service Data”. 9 Fitting the oil pump Fig. 10 before fitting, check that the oil pump is running smoothly. 2 Fit the oil intake line А with seal. Screw on the pressure-relief valve Б without seal. Before installing the oil pan, crank the engine to check whether the crank gear and the oil pumps run unimpeded and smoothly.
Stick new oil-pan gasket on to oil pan using grease and then bolt oil pan into place. 1 10 67