Removing and Installing Oil Spray Nozzle Removing oil spray nozzle D Drain off oil, see page 63 D Removing the oil pan, see page 65 Fig. 1 Unscrew the oil spray nozzle valve (arrowed) and remove with the oil spray nozzle. 1 Fig. 2 1 Oil spray nozzle valve 2 Oil spray nozzle 2 Note: The oil spray nozzles are provided with balls. When the oil spray nozzle valve is tightened at the factory, the balls are pressed into the crankcase where they make impressions which are used as marker points for installing the nozzle in the event of repairs. 1 2 Checking oil spray nozzle valve Fig. 3 Use a piece of wire to check whether the valve piston is easy to move. Opening pressure, see “Service Data”.
3 Installing the oil injection nozzle Fig. 4 Screw in the oil spray nozzle together with its valve. The balls of the oil spray nozzle must be located in the impressions designated for this purpose in the crankcase. This ensures that the nozzle is secured in the correct installation position. Turn the engine. The crankshaft drive or pistons must not collide with the oil injection nozzle. Tighten the mounting bolts with the prescribed tor- que. Tightening torque 70 Nm . . . . . . . . . . . . . . . . . . . . 4 68