MAN — Removing and fitting vibration damper, replacing front crankshaft gasket

Removing and fitting vibration damper, replacing front crankshaft gasket Removing vibration damper D Crank the engine to TDC. This ensures that it is easier to fit the graduated disc during subse- quent assembly work. D Relieve tension on the V-belt and remove the belt. Fig. 1 Block the crank gear. The picture shows a special tool that is to be fitted to the inspection hole in the flywheel housing. 1 Fig. 2 Remove the barring device and the delivery start pointer. 2 Fig. 3 Loosen the mounting bolts of the vibration damper. Note: Prior to removal mark the position of the vibration damper relative to the crankshaft.

This will ensure that in the subsequent re- assembly the graduated disc is in correct position. 3 Fig. 4 Remove vibration damper carefully. Caution: The vibration damper is sensitive to im- pacts. 4 69