MAN — Removing and fitting vibration damper, replacing front crankshaft gasket

Removing and fitting vibration damper, replacing front crankshaft gasket Replacing the front crankshaft gasket Fig. 5 Remove cover. Only replace the front crankshaft gasket as a com- plete unit, i.e. replace the bearing race and the radial shaft sealing ring. 5 Fig. 6 To remove the race, a puller (special tool, see page 185, item 13) is necessary. 6 Fig. 7 Pull off the bearing race. 7 Fig. 8 A special too is required to fit the bearing race. 1 2 Clean the inside of the bearing race and tail shaft. Coat the tail shaft with sealing compound “Antipor 46”. D Push race Ж and pressing sleeve З onto adapter В . 7 D Screw adapter Е securely onto the crankshaft.

D Tighten spindle А in adapter В with nut Г . 8 3 5 6 4 70