honda — Service Information

BF40AoBF50A Toraue Note Thread dia.

x pitch Item Nsm kgf-m Ibf*ft Extension/Mount Steering friction lever nut (Long tiller handle type) Lower motor mount housing bolt M8 x 0.75 9.5 0.95 6.9 M8 x 1.25 22 2.2 16 Stern bracket Stern bracket left side nut Stern bracket right side nut 7/8-14UNF M10 x 1.25 39 34 4.0 3.5 29 25 Tiller handle Steering bracket pivot lock nut Steering bracket pivot nut Steering bracket nut Throttle arm holder bolt Throttle grip bolt Under cover screw Cable holder bolt Emergency stop switch nut Connector bracket bolt Throttle cable pivot lock nut Switch bracket bolt M12 x 1.25 M12 x 1.25 MlOx 1.25 M5 x 0.8 M6 x 1 .O M5 x 0.8 M5 x 1 .O M16x 1.0 M6 x 1 .O M6 x 1 .O M5 x 0.8 54 29 34 4.5 7 2.2 7 1.3 7 1.3 4.5 5.5 3.0 3.5 0.45 0.7 0.22 0.7 0.13 0.7 0.13 0.45 40 22 25 3.3 5.1 1.6 5.1 0.9 5.1 0.9 3.3 Gas assisted damper Tilt lever nut M6 x 1 .O 6.5 0.65 4.7 NOTE:

Apply oil to the thread and seating surface. Tighten to the specified torque first, then tighten an additional 90"- 120". Clean off oil or grease from the crankshaft and flywheel mating surfaces (see page 6-1). Apply oil to the thread and seating surface of the flywheel bolt, then tighten them to the specified torque. If the split pin cannot be set by tightening the castle nut to the specified torque, tighten the castle nut addi- tionally until the split pin can be set. Do not exceed the maximum torque of 34 N-m (3.5 kgf-m, 25 Ibf-ft).

If the tab of the washer does not align with the groove of the gear case end nut by tightening it to the speci- fied torque, tighten the castle nut additionally until the groove aligns with the tab. Do not exceed the maxi- mum torque of 98 Nem (10.0 kgf-m, 72 Ibf-ft). Turn the friction lever to the right side fully, and hold it in this position and tighten the friction lever nut to the specified torque. Tighten the stern bracket nut to the specified torque, then turn it back to 180 - 210". 2-2