Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

100 Operation Section Transportation Information SEBU7645-06 11. Cover the exhaust opening. The turbocharger NOTICE Obey all state and local laws governing the weight, width and length of a load. Make sure the cooling system has proper antifreeze if moving machine to a colder climate. Observe all regulations governing wide foads. Illustration 105 g00040011 1. Chock the trailer or rail car wheels before you load the machine. (The trailer is shown.) 2. After the machine is positioned, connect the steering frame jock link in order to hold the front frame and the rear frame in place. 3. Lower the work tool to the floor of the transport vehicle. Move the transmission control lever to NEUTRAL. 4.

Engage the parking brake. 5. Turn the engine start switch key to OFF in order to stop the engine. Remove the engine start switch key. 6. Move all of the hydraulic control levers in order to relieve any trapped pressure. o 7. Move the switch for the hydraulic lever lock to the LOCKED position. . Turn the battery disconnect switch key to OFF and remove the battery disconnect switch key. 9. Lock the door and the access covers and attach any vandalism protection. area 10. Secure the machine with tie-downs when you as transporting the machine on a rail car or on the tractor-trailer. should not rotate when the engine is not operating. Damage to the turbocharger can result.