Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

101 SEBU7645-06 Operation Section Towing Information Towing Information 102975089 Machine SMCS Code: Retrieval 7000 Personal injury or death could result when towing a disabled machine incorrectly. Block the machine to prevent movement before releasing the brakes. The machine can roll free if it is not blocked. g00612933 Illustration 107 below, to properly When you tow the machine from the front, attach the tow line to the tow eyes on the frame (1). When you tow the machine from the rear, attach the tow line to the recovery hitch (2). These towing instructions are for moving a disabled Note: The recovery hitch is only for machine retrieval.

Do not use the recovery hitch for any of the following: Follow the recommendations perform the towing procedure. machine for a short distance at low speed. Move the machine at a speed of 2 km/h (1.2 mph) or less to a convenient location for repair. These instructions are only for emergencies. Always haul the machine if long distance moving is required. ¢ a lifting point ¢ a tie down point Shields must be provided on both machines. This will protect the operator if the tow line breaks or the tow bar breaks. * towing a trailer Do not allow an operator to be on the machine that is being towed unless the operator can control the steering and/or the brakes.

Do not use a chain for pulling a disabled machine. A chain link can break. This may cause personal injury. Use a wire cable with ends that have loops or rings. Place an observer in a safe position in order to watch Before you tow the machine, make sure that the tow line or the tow bar is in good condition. Make sure that the tow line or the tow bar has enough strength for the conditions that are involved. The strength of the tow line or of the tow bar should be at least 150 percent of the gross weight of the towing machine. This pertains to a disabled machine that is stuck the pulling procedure. The observer can stop the procedure, if necessary.

The procedure should be stopped if the cable starts to break. Also, stop the procedure if the cable starts to unravel. Stop pulling in the mud and to towing a disabled machine on a grade. e towing another vehicle whenever the towing machine moves without moving the towed machine. Keep the tow line angle to a minimum. Do not exceed a 30 degree angle from the straight ahead position. Quick machine movement could overload the tow line or the tow bar. This could cause the tow line or the tow bar to break. Gradual, steady machine movement will be more effective. Normally, the towing machine should be as large as the disabled machine.

Make sure that the towing machine has enough brake capacity, enough weight, and enough power. The towing machine must be able to control both machines for the grade that is involved and for the distance that is involved. Illustration 106 g00612930