Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

102 SEBU7645-06 Operation Section Towing Information You must provide sufficient control and sufficient braking when you are moving a disabled machine downhill. This may require a larger towing machine or additional machines that are connected to the rear of the disabled machine. This will prevent the machine from rolling away out of control. All situation requirements cannot be listed. Minimal towing machine capacity is required on smooth, level surfaces. On inclines, maximum towing machine capacity is required. When any towed machine is loaded, this machine must be equipped with a brake system that is operable from the operator compartment.

Illustration 109 Consult your Caterpillar dealer for the equipment that is necessary for towing a disabled machine. 924G g006139713 and 924Gz Towing with a Running Engine if the engine is running, the machine can be towed for a short distance under certain conditions. The power train and the steering system must be operable. Tow the machine for a short distance only. For example, pull the machine out of mud or pull the machine to the side of the road. The operator on the towed machine must steer the machine in the direction of the tow line. Comply with all of the instructions that are outlined in this topic. Illustration 110 g00101794 928G and IT28G Towing with a Stopped Engine b.

Remove the clamp (1) in order to allow free movement of the hose for the head end of the steering cylinder on the 928G and the IT28G When the disabled machine's engine is stopped, perform the following steps before you tow the machine. machine. c. Disconnect the hydraulic hose from the fitting (2) on the head end of the steering cylinder. 1. Reverse the hydraulic steering hose connections on one cylinder only. d. Disconnect the hydraulic hose from the fitting (3) on the rod end of the steering cylinder. e. Reconnect the hose for the rod end to the fitting for the head end and reconnect the hose for _sl the head end to the bottom rod end fitting.

This will allow the steering cylinders to move freely. NOTICE Be sure the cylinder hoses are connected correctly before operating the machine. With the hoses reversed, the steering system will not function. Illustration 108 g00887223 2. a. Remove the side panels. If failure of the internal transmission or of the drive train is suspected, remove the drive shafts.