Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

99 Operation Section Transportation Information SEBU7645-06 Transportation Information Lifting and Tying Down Machine 101902782 Roading the Machine SMCS Code: 7000 the Before you road a machine, consult your tire dealer for recommended tire pressures and for speed limitations. SMCS Code: 7000; 7500 Limitations for TON-kilometers per hour (TON-miles NOTICE Improper lifting or tie-downs can allow the load to shift and cause injury or damage. Install the steering frame lock link before lifting. per hour) must be obeyed. Consult your tire dealer for the speed limit of the tires that are used.

When you travel for long distances, schedule stops in order to allow the tires and the components to cool. Stop for 30 minutes after every 40 km (25 miles) or stop for 30 minutes after every hour. Inflate the tires to the correct air pressure. Use a self-attaching inflation chuck and stand behind the tire tread during the inflation. See Tire Inflation Information. Perform the Daily Inspection and measure the fluid levels in the various compartments. Check with the proper officials in order to obtain the required licenses and other similar items. lustration 104 g00285597 Proper lifting points are marked on the machine by this decal.

Proper tie-down points are marked Travel at a moderate speed. Observe all speed limitations when you road the machine. Disable the controls for the work tool when the machine is roaded. on the machine by this decal. Note: Refer to Operation and Maintenance Manual, “Operator Controls” for more information on disabling the controls for the work tool. Reference: Refer to Operation and Maintenance Manual, “Specifications” for the dimensions of the machine. i01696169 Shipping the Machine Use proper rated cables and proper rated slings for lifting the machine. Position the crane in order to lift SMCS the machine in a level plane. Investigate the travel route for overpass clearances.

Make sure that there will be adequate clearance if the machine that is transported is equipped with a The spreader bar widths must be sufficient in order to prevent contact with the machine. Code: 7000; 7500 ROPS, with a cab, or with a canopy. Install tie-downs at several locations. Place blocks in front of the wheels and behind the wheels. Before loading, remove ice, snow, or other slippery material from the loading dock and from the truck Obey the appropriate laws that govern the dimensions the machine. This should also be done in order to prevent a shift while the machine is moving in transit. of the load (weight, width and length).

Consult your Caterpillar dealer for shipping instructions for your machine. bed. This is done in order to prevent slippage of