124 Maintenance Section Bucket Tips - Inspect/Replace me ES | SEBU7645-06 iY 0/, Hlustration 132 g00590670 (4) Back of Pin-Master (5) Extractor llustration 134 g00101359 4. Install the new bucket tip onto the adapter. a. Place the Pin-Master on the bucket tooth. Note: The bucket tip can be rotated by 180 degrees in order to allow greater penetration or less penetration. b. Align extractor (5) with the pin. c. Strike the Pin-Master at the back of the tool (4) 5. Drive the pin through the bucket tip. The pin can be installed by using one of the following methods: and remove the pin. ¢ From the other side of the retainer, drive the pin through the bucket tip, the adapter, and the retainer.
* Use a Pin-Master. Follow Step 5.a through Step 5.e for the procedure. Note: To correctly install the pin into the retainer, the pin must be driven in from the right side of the tooth. Improper installation of the pin can result in the loss of the bucket tip. IHustration 133 19 g005908 (6) Retainer (7) Retaining washer (8) Adapter 2. Clean the adapter and the pin. 3. Fit retainer (6) into retaining washer (7). Install this assembly into the groove that is in the side of adapter (8). IHustration 135 goosso6es (4) Back of Pin-Master (9) Pin setter (10) Pin holder a. Insert the pin through the bucket tooth. b.
Place the Pin-Master over the bucket tooth and locate the pin in the hole of holder (10).