Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

125 SEBU7645-06 Maintenance Section Bucket Wear Plates - Inspect/Replace c. Strike the tool with a hammer at the back of the 4. Clean adapter (6). tool (4) in order to start the pin. Installation d. Slide pin holder (10) away from the pin and rotate the tool slightly in order to align pin setter (9) with the pin. 4. Clean the adapter and the area around the latch, if necessary. e. Strike the end of the tool until the pin‘is fully inserted. 2. Install the new bucket tip onto the adapter with a slight clockwise rotation. 6. After you drive the pin, make sure that the retainer & Te fits snugly into the pin groove. | ee K-Series Tip Removal 4. 5 i, y o g01124736 Illustration 138 3.

Install the retainer. Make sure that the retainer's latch catches under the tip pocket. 4. Make sure that the latch is properly seated by trying to remove the bucket tip. g01389463 Illustration 136 Note: Retainers are often damaged during the removal process. Caterpillar recommends the installation of a new retainer when bucket tips are rotated or replaced. 102003771 Bucket Wear Plates - Inspect/Replace SMCS Code: 6120-040; 6120-510 Personal bucket. injury or death can result from falling When working under or around the bucket or linkage, with the bucket raised, proper support must be provided for the bucket and/or the linkage.

Replace the wear plates before damage to the bottom of the bucket occurs. g01175361 illustration 137 1. Raise the bucket and block up the bucket. 1. Use a pry bar in order to disengage retainer (5). 2. Use the pry bar in order to remove retainer (5) from bucket tip (4). 3. Remove bucket tip (4) from adapter (6) with a slight counterclockwise rotation. 2. Loosen bolts and remove wear plates. 3. Install new wear plates. Tighten the bolts to the specified torque.