130 SEBU7645-06 Maintenance Section Cooling System Coolant Extender (ELC) - Add i00095664 Cooling System Coolant Extender (ELC) - Add SMCS Code: 1352-544-NL Pressurized system: Hot coolant can cause seri- ous burn. To open cap, stop engine, wait until ra- a diator is cooi. Then ioose the cap slowly to relieve the pressure. Illustration 149 g00928710 11. Maintain the coolant level between the ADD FULL marks on the overflow tank. When and 12. Install the cap for the overflow tank. 13. Stop the engine. 14. Replace the access panel. Close the access door.
For information about the addition of Extender to your a Caterpillar Extended Life Coolant is used, an extender must be added to the cooling system. See the Operation and Maintenance Manual, “Maintenance Interval Schedule” for the proper service interval. The amount of extender is determined by the cooling system capacity. Table 60 RECOMMENDED AMOUNT OF EXTENDER COOLING SYSTEM CAPACITY Recommended BY Amount cooling system, see the Operation and Maintenance Cooling System Capacity Manual, “Cooling System Coolant Extender (ELC) Add’ or consult your Caterpillar dealer.
22 to 30 L (6 to 8 US gal) 0.57 L (.60 qt) 30 to 38 L (8 to 10 US gal) 38 to 49 L (10 to 13 US gal) 0.71 L (.75 qt) 0.95 L (.95 qt) 49 to 64 L (13 to 17 US gal) 1.18 L (1.25 at) Flushing the Extended Life Coolant From the Cooling System Some engines utilize Extended Life Coolant. See the Operation and Maintenance Manual, “Maintenance Interval Schedule” in order to determine the service interval. If a Extended Life Coolant was previously used, flush the cooling system with clean water. No other cleaning agents are required.
Flushing a Standard Coolant From the Cooling System If you change the coolant of a machine to Extended Life Coolant from another type of coolant, use a of Extender For additional information on the addition of extender, see Operation and Maintenance Manual, “Caterpillar Coolant Recommendations’ or consult your Caterpillar dealer. 102091429 Cooling System Coolant Level - Check SMCS Code: 1395-535-FLV Caterpillar cleaning agent to flush the cooling system. A WARNING After you drain the cooling system, thoroughly fiush the cooling system with ciean water. Ali of the cleaning agent must be removed from the cooling system. Pressurized system: Hot coolant can cause serious burn.
To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure. NOTICE Excessive additive (greater than the recommended 6% initial fill) together with concentrations of antifreeze greater than 60% cause deposits to form and can result in radiator tube blockage and overheating.