131 Maintenance Section Cooling System Coolant Sample (Level 1) - Obtain SEBU7645-06 1. Open the engine access panel on the left side of the machine. 102161416 Cooling System Coolant Sample (Level 1) - Obtain SMCS Code: 1350-008; 1395-008; 7542 NOTICE Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any compo- VA © nent containing fluids. 1 @ Refer to Special Publication, NENG2500, “Caterpillar Illustration 150 g00928710 2.
Maintain the coolant level between the ADD and the FULL marks on the overflow tank when the cooling system is cool. Note: Refer to Operation and Maintenance Manual, “General Hazard Information” for information on containing fluid spillage. Tools and Shop Products Guide’ for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. Note: Level 1 results may indicate a need for Level 2 Analysis. Reference: See Operation and Maintenance Manual, “Cooling System Level - Check” in order to access the overflow tank for coolant sample.
Obtain the sample of the coolant as close as possible to the recommended sampling interval. In order to receive the full effect of S-O-S analysis, you must establish a consistent trend of data. In order to establish a pertinent history of data, perform consistent samplings that are evenly spaced. Supplies for collecting samples can be obtained from your Caterpillar dealer. Illustration 151 g00928711 3. Open the access panei on the ‘top of the engine compartment. 4. lf additional coolant is necessary, remove the cap on the overflow tank and add the appropriate coolant mixture. If you need to add coolant daily, check the cooling system for leaks. 5. Install the cap for the overflow tank.
Close the cover on top of the engine compartment. 6. Close the engine compartment. Use the following guidelines for proper sampling of the coolant: * Complete the information on the label for the sampling bottle before you begin to take the samples. « Keep the unused sampling bottles stored in plastic bags. « Obtain coolant samples directly from the coolant sample port. You should not obtain the samples from any other location. * Keep the lids on empty sampling bottles until you are ready to collect the sample. ¢ Place the sample in the mailing tube immediately after obtaining the sample in order to avoid contamination.