Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

132 SEBU7645-06 Maintenance Section Cooling System Coolant Sample (Level 2) - Obtain * Never collect sampies from expansion boities. « Never collect samples from the drain for a system. Submit the sample for Level 1 analysis. Level 1 analysis is a test of the properties of the coolant. For additional information about coolant analysis, see Special Publication, SEBU6250, “Caterpillar Machine Fluids Recommendations’ or consult your Caterpillar dealer. 102161468 Cooling System Coolant Sample (Level 2) - Obtain i01778060 Cooling System Water Temperature Regulator Replace SMCS Code:

1355-510; 1393-010 Replace the thermostat on a regular basis in order to reduce the chance of unscheduled downtime and of problems with the cooling system. Failure to replace the engine's thermostat on a regularly scheduled basis could cause severe engine damage. The thermostat should be replaced after the cooling system has been cleaned. Replace the thermostat while the cooling system is compietely drained or while the cooling system coolant is drained to a level SMCS Code: 1350-008; 1395-008; 7542 that is below the thermostat housing. NOTICE Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product.

Be prepared to collect the fluid with suitable containers before open- ing any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, “Caterpillar Tools and Shop Products Guide” for tools and supplies suitable to collect products. and contain fluids on Note: If you are only replacing the thermostat, drain the cooling system coolant to a level that is below the thermostat housing. Caterpillar engines incorporate a shunt design cooling system. It is mandatory to always operate the engine with a thermostat. “ Y Caterpillar Dispose of ail fluids according to local regulations and mandates. Reference:

See Operation and Maintenance Manual, “Cooling System Level - Check” in order to access the overflow tank for coolant sample. Obtain the sample of the coolant as close as possible to the recommended sampling interval. Supplies for collecting samples can be obtained from your illustration 152 g00615827 Illustration 153 g00615829 Caterpillar dealer. Refer to Operation and Maintenance Manuai, “Cooling System Coolant Sample (Level 1) - Obtain” for the guidelines for proper sampling of the coolant. Submit the sample for Level 2 analysis. The Level 2 analysis is a comprehensive chemical evaluation of the coolant.

This analysis is also a check of the overall condition of the inside of the cooling system. Reference: For additional information about coolant analysis, refer to Special Publication, SEBU6250, “Caterpillar Machine Fluids Recommendations’ or consult your Caterpillar dealer.