Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

133 Maintenance Section Differential and Final Drive Oil - Change SEBU7645-06 1. Loosen the hose clamp and remove the hose from the thermostat housing assembly. 2. Remove the bolts from the thermostat housing assembly. Remove the thermostat housing assembly. 3. Remove the gasket, the thermostat, and the seal from the thermostat housing assembly. 4. Install a new seal in the thermostat housing assembly. Install a new thermostat and a new gasket. Install the thermostat housing assembly on the engine cylinder head. m The thermostats can be reused under the following conditions. g00615871 Illustration 155 1. Remove the drain plugs for the front differential (1) and for the rear differential (2).

Allow the oil to drain into a suitable container. « The thermostat is tested and the thermostat meets test specifications. 2. Clean the drain plugs and install the drain plugs. * The thermostat is not damaged. « The thermostat does not have excessive buildup of deposits. 5. Install the hose. Tighten the hose clamp. 6. Refill the cooling system. See Operation and Maintenance Manual, “Lubricant Viscosities” and Operation and Maintenance Manual, “Refill Capacities”. 103024515 Differential and Final Drive Oil - Change IWustration g00615872 156 3. Remove the dipstick/fill plug for the front SMCS Code:

3278-044-OC; 4011-044-OC Wipe the covers and surfaces around openings - before you check the oil. Wipe the covers and surfaces around openings before you add oil. differential and remove the dipstick/fill plug for the rear differential. 4. Add 0.5 L axle. (.53 gt) of Hydraulic Oil Additive to each 5. Fill the axles with oil. Maintain the oil between the “ADD” mark and the “FULL” mark on the dipstick/fill plug of each differential. See Operation and Maintenance Manual, “Lubricant Viscosities” and Operation and Maintenance Manual, “Refill Capacities”. Note: Install the dipstick/fill plug completely before you check the oil level.

If the dipstick/fill plug is not installed completely, an incorrect oil level reading can occur. illustration 154 g00615911