140 Maintenance Section Engine Oi] Sample - Obtain SEBU7645-06 « Suifur content in the fuel is between 0.50% and 1.00%. Engine Oil Sample - Obtain An oil change interval of “Every 125 Service Hours” SMCS Code: 1348-008; 7542-008 is required when the following condition occurs: * Sulfur content in the fuel is above 1.00%. Refer to the results of the S-O-S oil analysis in order to determine if the oil change interval should be decreased. Consult your Caterpillar dealer for detailed information regarding the optimum oil change interval. Hlustration 175 g00614035 Use the sampling vaive in order to obtain a sample of the engine oil.
The engine must be running in order to take a sample of the engine oil. Refer to Special Publication, SEBU6250, “Caterpillar Machine Fluids Recommendations’, “S:O-S Oil Analysis” for information that pertains to obtaining an oil sample. Refer to Special Publication, PEHP6001, “How To Take A Good Oil Sample” for more g00920972 The crankcase drain valve (1) is on the left side of the oil pan. information about obtaining an oil sample. 102154566 Engine Oil and Filter - Change SMCS Code: 1308-510; 1348-044 The normal oil change interval is “Every 500 Service Hours or Three Months” when the following conditions are met: ¢ Illustration 176 1. Remove the piug from the bottom of the drain hose (2).
2. Open the crankcase drain valve and drain the oil into a suitable container. Close the crankcase drain valve. Install the plug into the bottom of the drain hose. 3. Open the engine access door on the left side of the machine. Caterpillar oil or API Specification CG-4 multigrade oil is used. * Caterpillar filters are used. ¢ The altitude does not exceed 2300 m (7545 ft). * Sulfur content in the fuel is between 0.05% and 0.50%. An oil change interval of “Every 250 Service Hours or every month” is required when the following conditions occur: ¢ Caterpillar oil or API Specification CG-4 multigrade oil is not used. ¢ The altitude exceeds 2300 m (7545 ft). Illustration 177 g00892461