141 Maintenance Section SEBU7645-06 Engine Valve Lash - Check 4. Remove the filter element with a strap type wrench. Refer to Operation and Maintenance Manual, “Oil Filter - Inspect”. 5. Clean the filter mounting base with a clean cloth. Make sure that the old filter gasket has been removed. Note: Caterpillar filters are designed to ensure a ready supply of oil with every engine start. Use of approved Caterpillar filters is recommended on this 103854660 Engine Valve Lash - Check SMCS Code: 1105-025 Refer to the Service Manual! for the complete adjustment procedure for the engine valve lash.
A qualified mechanic should adjust the engine valve lash because special tools and training are required. machine. 102450207 6. Apply a thin film of clean engine oil to the sealing surface of the new filter element. Fuel System - Prime 7. SMCS Code: Install the new filter element by hand. When the gasket contacts the filter base, tighten the filter for an additional 3/4 turn. 8. Open the engine access door on the right side of the machine. 1250-548 If air enters the fuel system, the air must be purged before the engine can be started. Air can enter the fuel system when the following events occur: * The fuel tank is empty or the tank has been partially drained.
¢ The low pressure fuel lines are disconnected. « A leak exists in the low pressure fuel system. ¢ The fuel filter is replaced. Use the following procedure in order to remove air from the fuel system: Illustration 178 goos09903 9. Remove the oil filler plug (3). Fill the crankcase with new oil. See Operation and Maintenance Manual, “Lubricant Viscosities” and Operation and Maintenance Manual, “Refill Capacities”. Clean the oil filler plug and install the oil filler plug. 10. Start the engine and allow the oil to warm. Check for leaks. 11. Stop the engine and allow the oil to drain back into the oil pan. Maintain the oil level in the crosshatched region of the engine oil dipstick (4).
Add oil, if necessary. 12. Close the engine access doors. lilustration 179 Side of the fuel injection pump (1) Fuel injection pump (2) nut 4. Loosen nut (2) on the fuel injection pump. g00898 190