Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

143 SEBU7645-06 Maintenance Section Fuel System Primary Filter (Water Separator) - Drain 102154630 Fuel System Primary Filter (Water Separator) - Drain The water separator element is located in the engine compartment on the right side of the machine. SMCS Code: 1263-543 The water separator is located in the engine compartment on the right side of the machine. Note: This unit has a dual purpose. The element serves as a water separator and a fuel filter. INustration 184 g00625150 1. Open the drain (1) on the water separator bowl. Allow the water and fuel to drain into a suitable container. 2. Support the water separator element and rotate the locking ring (2) counterclockwise.

Remove the locking ring. g00625139 Illustration 183 1. Loosen the drain valve on the bottom of the water separator. Allow the water and the sediment to drain into a suitable container. 3. While the water separator bowl is attached, remove the water separator element from the mounting base. 4. Remove the water separator bowl (3) from the filter element. Clean the water separator bowl and clean the O-ring groove. 2. Tighten the drain valve. 3. If the engine fails to start, change the fuel filter. If there is a power loss, change the fuel filter. 4, Tighten the drain valve and close the engine access door. Note: The water separator bowl is reusable. Do not discard the water separator bowl. 5.

Inspect the O-ring seal of the water separator bowl for damage. Replace the O-ring seal, if necessary. 6. Lubricate the O-ring seal with clean diesel fuel or 102154657 Fuel System Primary Filter (Water Separator) Element Replace SMCS Code: 1260-510; 1263-510-FQ lubricate the O-ring seal with motor oil. Place the O-ring seal in the groove in the water separator bowl. 7. Spin the water separator bowl onto the new filter element by hand until the filter element is snug. Do not use tools to tighten the filter element. 8. Install the new water separator element. Rotate NOTICE the locking ring clockwise in order to fasten the filter to the mounting base.

Do not fill fuel filters with fuel before installing them. The fuel will not be filtered and could be contaminated. Contaminated fuel will cause accelerated wear to fuel 9. Prime the fuel system in order to fill the water system parts. The fuel system should be primed prior separator element with fuel. Refer to Operation to starting the engine. Note: This unit has a dual purpose. The element serves as a water separator and a fuel filter. and Maintenance Manual, “Fuel System - Prime”.