144 Maintenance Section Fuel System Secondary Filter - Replace SEBU7645-06 102092171 101793682 Fuel System Secondary Filter - Fuel Tank Cap and Strainer - Replace Clean SMCS Code: 1261-510-SE SMCS Code: 1273-070-Z2; 1273-070-STR The fuel tank cap is located on the right side of the machine. LL LT S \ 1. Open the engine access door on the right side of the machine. = The fuel filter is located in the engine compartment on the right side of the machine. /7 / ~ WN Do not fill fuel filters with fuel before installing them. Contaminated fue! will cause accelerated wear to fuel system parts. BR NOTICE illustration 186 1. g00917717 Remove fuel tank cap (1) and strainer (3) from fuel tank (4).
Remove seai (2) from the cap. 2. Wash the strainer and the fuei tank cap in a clean, nonflammable solvent. Hlustration 185 g006 16649 2. Remove the fuel filter. Inspect the fuel filter for debris by cutting the filter open. Discard the filter properly. 3. Install the strainer into the filler opening. 4. Inspect the seal for damage. Replace the seal, if necessary. Install the fuel tank cap. i03796298 3. Clean the mounting base of the fuel filter. Remove any part of the old seal that remains on the mounting base of the fuel filter. 4. Coat the seal of the new fuel filter with clean diese! fuel. 5. Install the new fuel filter by hand.
When the seal contacts the base, tighten the filter for an additional three quarters of a turn. 6. Prime the fuel system. Refer to Operation and Maintenance Manual, “Fuel System - Prime”. 7. Close the engine access door. Hydraulic System Oil - Change SMCS Code: 5095-044 Operate the machine for a few minutes in order to warm the hydraulic system oil. The machine should be level . Lower the bucket to the ground and apply slight downward pressure. Engage the parking brake and stop the engine.