145 Maintenance Section SEBU7645-06 Hydraulic System Oil - Change llustration 187 go0910320 902053195 Illustration 190 930G 1. Remove the hydraulic tank filler cap. 2. The hydraulic tank drain valve is located on a manifold near the articulation hitch for the 928G, 930G, and the IT28G. The hydraulic tank drain valve is located under the right side of the cab behind a panel on the 924G and the 924Gz. Open the drain valve and allow the hydraulic oil to drain into a suitable container. Note: The 930G has the same manifold as the 928G and the IT28G. The drain valve is located at the end of the manifold on the 930G. 3. Close the drain valve.
Illustration 188 g00923426 4 Open the engine access door on the right side of the machine. 924Gz/924G 5. Change the hydraulic system filter and the hydraulic tank breather. Refer to Operation and Maintenance Manual, “Hydraulic System Oil Filter - Change’. 6. Fill the hydraulic system oil tank. Refer to Operation and Maintenance Manual, “Lubricant Viscosities” and Operation and Maintenance Manual, “Refill Capacities”. 7. Inspect the gasket on the hydraulic tank filler cap for damage. Replace the gasket, if necessary. 8. Install the hydraulic tank filler cap. . Illustration 189 928G/IT28G 00910326 ; ; 9. Start the engine and run the engine for a few minutes.
The cooling fan should be operating and the brake oil pressure indicator should go out. If the cooling fan is not operating or the brake oil pressure indicator does not go out, repeat Step 6 and Step 8.