146 SEBU7645-06 Maintenance Section Hydraulic System Oil Filter - Replace Illustration 191 g00910327 10. Maintain the hydraulic oil level between the top and the bottom mark on the sight gauge. Add oil, INustration 193 3 Remove the filter element with a strap type wrench. if necessary. Note: The oil must be free of bubbles. If bubbles are present in the oil, air is entering the hydraulic system. g00911775 . Clean the filter element mounting base. Remove any part of the filter element gasket that remains on the filter element mounting base. a Inspect the suction hoses and hose clamps. 11. Stop the engine. 12. If necessary, tighten any loose clamps and any loose connections.
Replace any damaged hoses. 13. Close the engine access door. 102310396 Hydraulic System Oil Filter Replace SMCS Apply a thin coat of oil to seal on the new filter. Install a new hydraulic oil filter hand tight until the seal of the hydraulic oil filter contacts the base. Note the position of the index marks on the filter in relation to a fixed point on the filter base. There are rotation index marks on the hydraulic oil filter that are spaced 90 degrees or 1/4 of a turn away from each other. When you tighten the hydraulic oil filter, use the rotation index marks as a guide. Tighten the filter according to the instructions that are printed on the filter. Use the index marks Code:
5068-510 as a guide. For non-Caterpillar filters, use the instructions that are provided with the filter. You may need to use a filter strap wrench, or another suitable tool, in order to turn the filter to the amount that is required for final installation. Make sure that the installation tool does not damage the filter. llustration 192 g00910320 1. Remove the hydraulic tank filler cap. 2. The hydraulic oil filter is located in the back of the machine. Open the engine access door on the right side of the machine. Illustration 194 g00910327