Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

67 SEBU7645-06 Operation Section Machine Operation Loader Controls Control Console 901118936 Illustration 54 Standard Lever Controls and Optional Joystick Control DUMP oy) (E) Joystick Contro! (F) Flow Control (C) 3rd Auxiliary Hydraulic Control Lever (A) Dump Control Lever (B) Lift Control Lever (D) 4th Auxiliary Hydraulic Control Lever LOWER (4) — Push the control forward in order to lower the work tool. The control (1) — Push the control to this position in order to tilt the work tool. will return to the HOLD position when the control is released. () TILT BACK (2) — Push the control to this position in order to tilt the work tool backward.

(x8) RAISE (5) — Pull the control backward in order to raise the work tool. Release the control in order to stop lifting the work tool. The control is detented in the maximum tilt back position. The control will stay in the detent and the work tool will continue to tilt back until the work tool reaches the preset location for the tilt kickout. Then, the control will return to the HOLD position. FLOAT (3) — Push the contro! forward into the detent. The work tool will lower to the ground. The work tool will float with the The control will remain in the FLOAT position until the control is pulled out of the detent. The control NOTICE Never use the FLOAT position to Jower a loaded buck- et.

Machine The control will stay in the detent and the work tool will continue to rise until the work tool reaches the lift kickout height. Then, the control will return to the HOLD position. — When you release the control, the control will return to the center for the HOLD position. The work tool will remain in the selected position. position when the control is released. too fast. position when the The control is detented in the fully raised position (6). HOLD contour of the ground. will return to the HOLD The control will return to the HOLD control is released.

3rd Auxiliary Hydraulic Control Lever (C) (if Equipped) Move the control to position (7) in order to pressurize the left supply line. damage can result from a bucket that falls Move the control to position (8) in order to pressurize the right supply line. Position (8) also has a detent.