Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

72 SEBU7645-06 Operation Section Machine Operation or details, see the Operation and Maintenance Manual, “Engine Starting”. Governor Conirol Gauges 5 Up TAN =\ ED MS } , hh LF a 2 Hydraulic Oil Temperature (1) — This gauge indicates the temperature of the hydraulic oil. If the needle is in the red range, the hydraulic oil temperature is too high. Coolant Temperature (2) — This gauge indicates the temperature of the engine coolant. If the needle is in the red range, the coolant temperature is too high. Digital Display(3) — The digital display shows the gear and direction of the transmission. The digital display also shows the RPM of the machine.

Speedometer (4) — This gauge indicates the ground speed of the machine. Digital Display (5) — The digital display shows the hour meter of the machine until you put the machine into gear. The display shows the odometer after the transmission is put into gear. Transmission Oil Temperature (6) 3 Illustration 64 g00884921 The governor pedal (1) is located on the floor of the operator's compartment. Push down on the pedal in order to increase the engine speed. Release the pedal in order to decrease the engine speed. Engine Speed Control Push in the top half of switch (2) in order to activate the engine speed control.

When the desired speed is reached, push the top of the switch (3) in order to set the machine speed. In order to increase the desired speed, push in the bottom of the switch (3). In order to decrease the desired speed, push the top of the switch (3). Press the service brake pedal in order to disengage the engine speed control temporarily. Push in the bottom half of switch (3) in order to resume the preset speed that was set by the operator. Note: The digital displays can be changed from English to Metric units. Contact your Caterpillar Dealer in order to change the digital display. ()) Vp — Tee se g00884120 Illustration 63 — O31 This gauge indicates the temperature of the transmission oil.

If the needle is in the red range, the transmission oil temperature is too high. Fuel Level (7) — This gauge indicates the amount of fuel that remains in the fuel tank. If the needle is in the red range, the fue! level is low. Push in the bottom half of switch (2) in order to disengage the engine speed control. This will erase the preset speed that was set by the operator. Gear changes can be initiated by changing the set speed for the engine speed control or by increasing the load on the machine. The engine speed control will activate in all forward gears and all reverse gears. The engine speed control will remain active during automatic upshifts and downshifts.