TESTING AND ADJUSTING STANDARD VALUE TABLE FOR CHASSIS RELATED PARTS STANDARD VALUE TABLE FOR CHASSIS RELATED PARTS fl The Standard value for new machine and Service limit value in the table below are all values when measured in the heavy-duty mode. Applicable model PC130-6K + PC150LGP-6K SM rev. PC130/150LGP-6K 20-3 Cate- gory Item Measurement conditions Unit Standard value for new machine Service limit value Engine speed At 1-pump relief · Hydraulic oil temperature: 45 – 55˚C · Engine water temperature: Within operating range · 1-pump relief: Arm relief rpm 1,950 ± 100 1,950 ± 100 At 1-pump relief (power max.) Min. 1,800 Min.
1,800 Speed when auto deceleration is actuated · Fuel control dial at MAX. · Control levers at neutral. 1,400 ± 200 1,400 ± 200 Spool stroke Boom control valve fl ( ): Value when active mode is actuated mm a b a b Arm control valve 8 ± 0.5 8 ± 0.5 (9.5 ± 0.5) 8 ± 0.5 8 ± 0.5 (9.5 ± 0.5) Bucket control valve 8 ± 0.5 8 ± 0.5 48 ± 0.5 48 ± 0.5 Swing control valve Travel control valve Travel of control levers Boom control lever · Center of lever knob · Measure max.
value to end of travel · Engine stopped · Excluding neutral play mm 85 ± 10 85 ± 10 Arm control lever 85 ± 10 85 ± 10 Bucket control lever 85 ± 10 85 ± 10 Swing control lever 85 ± 10 85 ± 10 Travel control lever 112 ± 15 112 ± 15 Play of control lever 10 ± 5 10 ± 5