TESTING AND ADJUSTING STANDARD VALUE TABLE FOR CHASSIS RELATED PARTS Applicable model PC130-6K + PC150LGP-6K SM rev. PC130/150LGP-6K 20-5 Cate- gory Item Measurement conditions Unit Standard value for new machine Service limit value Swing Overrun when stopping swing Work equipment posture Max. reach Empty BKP00102 · Engine at full throttle · Hydraulic oil temperature: 45 – 55˚C · Stop after swinging one turn and measure distance that swing circle moves Deg. 75 ± 10 Max. 90 Time taken to start swing Work equipment Max. reach posture Empty BKP00326 · Engine at full throttle · Hydraulic oil temperature:
45 – 55˚C · In heavy-duty operation mode · Time taken to swing 90˚and 180˚ from starting position 90˚ Sec 2.9 ± 0.3 Max. 3.5 180˚ 4.0 8.5 Time taken to swing Work equipment posture Max. reach Empty BKP00102 · Engine at full throttle · Hydraulic oil temperature: 45 – 55˚C · In heavy-duty operation mode · Swing one turn, then measure time taken to swing next 5 turns 26.55 ± 3.45 26.55 ± 4.75 Hydraulic drift of swing 1 5 ° BKP00103 · Engine stopped · Hydraulic oil temperature: 45 – 55˚C · Set machine on 15˚ slope, and set upper structure at 90˚ to the side. · Make match marks on swing circle outer race and track frame. · Measure distance that counter marks move apart after 5 minutes.
mm 0 0 Leakage from swing motor · Engine at full throttle · Hydraulic oil temperature: 45 – 55˚C · Swing lock switch ON · Relieve swing circuit. ¬/min 3 6