Komatsu — 20 Testing and adjusting

TESTING AND ADJUSTING STANDARD VALUE TABLE FOR CHASSIS RELATED PARTS Applicable model PC130-6K + PC150LGP-6K SM rev. PC130/150LGP-6K 20-7 Cate- gory Item Measurement conditions Unit Standard value for new machine Service limit value Travel Hydraulic drift of travel 12˚ BKP00108 · Engine stopped · Hydraulic oil temperature: 45 – 55˚C · Stop machine on 12˚ slope with sprocket facing straight up the slope. · Measure the distance the machine moves in 5 minutes. mm 0 0 Leakage of travel motor Lock pin BKP00109 · Engine at full throttle · Hydraulic oil temperature: 45 – 55˚C · Lock shoes and relieve travel circuit. ¬/mm Max. 5 Max.

10 Work equipment Hydraulic drift of work equipment Total work equipment (hydraulic drift at tip of bucket teeth) Posture for measurement 810 kg BKP00110 · Place in above posture and measure extension or retraction of each cylinder and downward movement at tip of bucket teeth. · Bucket: Rated load · Horizontal, flat ground · Levers at neutral · Engine stopped · Hydraulic oil temperature: 45 – 55˚C · Start measuring immediately after setting. · Measure hydraulic drift every 5 minutes, and judge from results for 15 minutes. mm Max. 460 Max. 700 Boom cylinder (amount of retraction of cylinder) Max. 8 Max. 12 Arm cylinder (amount of extension of cylinder) Max. 90 Max.

90 Bucket cylinder (amount of retraction of cylinder) Max. 40 Max. 40