Komatsu — 20 Testing and adjusting

TESTING AND ADJUSTING STANDARD VALUE TABLE FOR CHASSIS RELATED PARTS Applicable model PC130-6K + PC150LGP-6K SM rev. PC130/150LGP-6K 20-8 Cate- gory Item Measurement conditions Unit Standard value for new machine Service limit value Work equipment Work equipment speed Boom Bucket teeth in contact with ground ↔ · Cylinder fully extended · Empty BKP00111 Engine at full throttle Hydraulic oil temperature: 45 – 55˚C RAISE Heavy- duty Active opera- mode tion mode Sec 3.8 ± 0.4 Max. 4.4 3.8 ± 0.4 Max. 4.4 LOWER Heavy- duty Active opera- mode tion mode 2.9 ± 0.5 Max. 3.5 2.3 ± 0.5 Max.

2.9 Arm Cylinder fully retracted · ↔ Fully extended · Empty BKP00112 Engine at full throttle Hydraulic oil temperature: 45 – 55˚C CURL Heavy- Active duty mode operation mode 3.7 ± 0.5 Max. 4.5 3.2 ± 0.4 Max. 4.0 DUMP Heavy- duty Active opera- mode tion mode 3.1 ± 0.3 Max. 3.7 3.1 ± 0.3 Max. 3.7 Bucket Cylinder fully ↔ · Fully extended · Empty retracted BKP00113 Engine at full throttle Hydraulic oil temperature: 45 – 55˚C CURL Heavy- duty Active opera- mode tion mode 2.9 ± 0.3 Max. 3.7 2.9 ± 0.3 Max. 3.7 DUMP Heavy- duty Active opera- mode tion mode 2.3 ± 0.3 Max. 2.9 2.3 ± 0.3 Max.

2.9 Time lag Boom · · · BKP00114 Lower boom and measure time taken from point where bucket contacts ground to point where chassis rises from ground Engine at low idling Hydraulic oil temperature: 45 – 55˚C Max. 3 Max. 4 Arm · · · BKP00115 Stop arm suddenly and measure time taken for arm to stop Engine at low idling Hydraulic oil temperature: 45 – 55˚C Max. 2 Max. 3