Cummins — CELECT ENGINES

Injectors - Installation Engine Assembly (00-02) N14 Page 0-100 Use service tool, Part No. 3823819, to slide the two water tubes into the adjacent water manifold. Install the two water tube retainer clamps. Install and tighten the retainer clamp capscrews. Torque Value: 45 [33 ft-lb] Injectors - Installation CELECT™Engines NOTE: When installing injectors for reuse, new o-rings must be installed on the injector. NOTE: The CELECT™injectors require three different in- jector o-rings. The o-rings are color coded as follows: Top o-ring - Black Center o-ring - Brown Bottom o-ring - Black with a white identification dot. Lubricate the o-rings with lubricating oil just before installation. Caution:

Do not strike the top stop spring cage when installing CELECT™injectors. Using the CELECT™injector puller/installer, Part No. 3823579, install the injector into the cylinder head injec- tor bore with the injector solenoid valve facing the intake side of the engine. After partial installation of the injector, take precautions to center the solenoid valve between the valve springs. Avoid contact with the spring coils. If the injector is con- tacting a valve spring, use a screwdriver to position the injector again. Warning: Do not strike or pry on the solenoid. Other- wise, injector damage will occur. Continue driving the injector into the bore using the puller/ installer, Part No. 3283579.