Engine Assembly (00-02) Injectors - Installation N14 Page 0-101 If injector puller, Part No. 3823579, is not available, a screwdriver can be used to install the injector by putting the screwdriver on the injector body at the base of the injector solenoid and striking the screwdriver with a soft mallet. Do not strike on the injector solenoid or on the top stop spring cage. Warning: The injector must be fully seated before in- stalling the hold down clamp. The hold down clamp can not pull the injector into the bore. Engine damage can occur if the injector is not fully seated. Install the hold down clamp capscrew. Torque Value:
54 [40 ft-lb] STC Engines Install the oil manifold connector using new o-rings. Lu- bricate the o-rings and the rocker housing bores with vegetable oil. Also lubricate the internal jumper tube and o-ring and carefully align them with the external manifold connector during assembly. A snap will be felt as the oil manifold connector seats into the rocker lever housing. Install the two mounting capscrews and tighten. Torque Value: 24 [18 ft-lb] Install the internal oil tube using a new grommet seal and new o-rings. Lubricate the o-rings with vegetable oil.