Push Tubes - Installation Engine Assembly (00-02) N14 Page 0-102 NOTE: When installing injectors for reuse, new o-rings must be installed on the injector. Lubricate the o-rings with lubricating oil just before installation. Install the injector and hold down clamp. Use injector puller, Part No. 3822697, to install STC in- jectors. Make sure the injector oil feed is aligned over the oil transfer tube. Install the hold down clamp capscrew. Torque Value: 54 [40 ft-lb] Push Tubes - Installation Use clean 15W-40 oil to lubricate the ball end of the push tubes. NOTE: The injector push tubes (1) are larger in diameter than the valve push tubes (2).