Cummins — CLEANING

Cylinder Head Cylinder Head - Ring Dowel Replacement (02-04) N14 Page 2-27 Cylinder Head - Ring Dowel Replace- ment (02-04) Removal Caution: Do not damage the surface or the ring dowel hole during removal of the dowel. Use a pliers or a locking pliers to remove the damaged ring dowel. Use a blunt punch, if necessary, to bend the ring in for removal. Installation Caution: Do not use a hammer or damage to the dowel will result. Use a plastic mallet to install the ring dowel. Cylinder Head - Replacing the Valve Seat Inserts (02-05) Disassembly Use slide hammer assembly, Part No. 3376617, and valve seat extractor, Part No. ST-1279-1, to remove the valve seat inserts from the cylinder head.

Cleaning Use a wire brush and solvent to clean the deposits from the valve seat insert bores. Use solvent to clean the cylinder head. Dry with com- pressed air.