Cylinder Head - Replacing the Valve Seat Inserts (02-05) Cylinder Head N14 Page 2-28 Inspection Visually inspect the insert bore for cracks or damage. NOTE: If cracks or damage are found, it is possible to repair the cylinder head by machining the insert bore for oversize valve seat inserts. Refer to the Alternative Repair Manual, Bulletin No. 3379035. Measure the valve seat insert bore depth in the cylinder head. Insert Bore Depth (Standard Insert) mm in 9.39 MIN 0.370 9.52 MAX 0.375 NOTE: If the valve seat insert bore depth does not meet the specifications given, it is possible to repair the cylinder head by machining the insert bore for oversize valve seat inserts.
Refer to the Alternative Repair Manual, Bulletin No. 3379035. Measure the inside diameter of the valve seat insert bore in the cylinder head. Insert Bore I.D. (Standard Insert) mm in 50.787 MIN 1.9995 50.813 MAX 2.0005 NOTE: If the valve seat insert bore inside diameter does not meet the specifications given, it is possible to repair the cylinder head by machining the insert bore for oversize valve seat inserts. Refer to the Alternative Repair Manual, Bulletin No. 3379035. Assembly Install the base and swivel of valve seat insert tool, Part No. ST-257, on the cylinder head to guide the valve seat driver. NOTE: The insert chamfer (1) must be installed toward the bottom of the counterbore.
Use the valve seat driver and an arbor press to push the valve seat insert into the counterbore. NOTE: Make sure the insert is at the bottom of the counterbores.