Cummins — CLEANING AND INSPECTION

Rocker Lever - Cleaning and Inspection for Reuse (03-01) Rocker Lever Housing Assembly N14 Page 3-10 Measure the rocker lever bushing bore inside diameter. Rocker Lever Bushing I.D. (Installed) mm in 34.89 MIN 1.3735 34.99 MAX 1.3775 NOTE: Replace the rocker lever bushings which are worn beyond the maximum limit. Refer to Rocker Lever Bushing - Replacement (03-02). Use steam or solvent to clean the rocker lever adjusting screw and nuts. Dry with compressed air. Visually inspect the adjusting screws and the nuts for distorted threads. Visually inspect the adjusting screw. The contact area must be smooth with an even seating pattern.

If parallel scratches are found in the contact area, the adjusting screw must be replaced. This condition is nor- mally found with worn push rods that will also require replacement.