Rocker Lever Housing Assembly Rocker Lever - Cleaning and Inspection for Reuse (03-01) N14 Page 3-11 Assembly Use clean 15W-40 oil to lubricate the threads of the ad- justing screws. Install the adjusting screw and lock nut in each rocker lever. Do not tighten the lock nuts. Install the exhaust (1), injector (2), and intake (3) rocker levers onto the shaft. The two levers closest to the center of the rocker housing are the intake valve rocker levers. The levers closest to the end of the rocker housing are the exhaust valve rocker levers. Caution: If the adjusting screws protrude beyond the maximum listed below, the push rods can be damaged when the housing capscrews are tightened.
Do not at- tempt to install the rocker lever or shaft assemblies again without resetting the lash. Loosen the rocker lever adjusting screws so there is a maximum of 32 mm [1.250 inches] from the top surface of the lever and the ball end of the adjusting screw.