Rocker Lever Bushing - Replacement (03-02) Rocker Lever Housing Assembly N14 Page 3-12 Place the rocker lever assembly over the dowel pin and dowel ring located in the rocker housing. NOTE: Do not damage the dowel pin and dowel ring located in the rocker housing. Make sure the push rods are in the cam follower sockets and align the push rods with the injector and valve rocker lever adjusting screws. Alternately tighten the rocker shaft capscrews in 54 N•m [40 ft-lb] increments to 156 [115 ft-lb]. Adjust the valves and injectors. Refer to Procedure 7-04 in the N14 Troubleshooting and Repair Manual, Bulletin No. 3810456.
Rocker Lever Bushing - Replacement (03-02) Disassembly Install the rocker lever in an arbor press. Use rocker lever block and mandrel set (1), Part No. ST-691, and a support (2) to push the bushing out of the rocker lever.