Rocker Lever Housing Assembly Rocker Lever Bushing - Replacement (03-02) N14 Page 3-13 Use a 240 grit, or finer, emery cloth to remove any rough edges or burrs from the bore of the rocker lever. Use solvent to clean the rocker levers. Dry with com- pressed air. Inspection NOTE: If cracks in the rocker lever are suspected, refer to Rocker Lever - Magnetic Crack Inspection (03-03). Measure the inside diameter of the rocker lever bore. Rocker Lever Bore I.D. mm in 36.474 MIN 1.436 36.500 MAX 1.437 NOTE: If the rocker lever bore is worn larger than the max- imum specification, the rocker lever must be replaced. Assembly NOTE:
The oil holes in the rocker lever bore (1) and the oil holes in the bushing (2) must be aligned correctly to supply oil to the adjusting screws, the crossheads, and the injector link. Install the bushing in the valve rocker lever with the split clinch joint (1) toward the top of the lever. The short ‘‘slot hole’’ (2) must be aligned with the oil hole to the adjusting screw. The long ‘‘slot hole’’ (3) must be aligned with the oil hole to the lever pad.