Rocker Lever - Magnetic Crack Inspection (03-03) Rocker Lever Housing Assembly N14 Page 3-14 Install the bushing in the injector rocker lever with the split clinch joint toward the top of the lever. The ‘‘square must be aligned with the oil hole to the adjusting screw. The ‘‘slot hole’’ must be aligned with the oil hole to the injector link socket. Use an arbor press and a rocker lever block and mandrel set, Part No. ST-691, to push the bushing into the rocker lever. Rocker Lever - Magnetic Crack Inspection (03-03) Refer to the Alternate Repair Manual, Bulletin No. 3379035, for procedures to magnetically check for cracks in the rocker levers.
Rocker Housing Covers - Cleaning and Inspection for Reuse (03-04) Cleaning Remove the crankcase breather element, if used, and the oil filler cap. Refer to Procedure 2-05 in the Trouble- shooting and Repair Manual N14 Engines, Bulletin No. 3810456. Remove the gaskets. Steam clean the covers, and dry with compressed air. NOTE: The valve cover gaskets are reuseable. Do not dam- age the gasket when removing or cleaning.