Lubricating Oil Cooler Assembly - Rebuild (07-11) Lubricating Oil System N14 Page 7-36 Install the oil cooler bypass valve into the transfer housing. Place the spacer plate and a new spacer gasket on the oil cooler support. Use two of the connection retainer capscrews to keep the gasket and plate loosely aligned on the support. Install the transfer housing, a new transfer connection gasket, and the six capscrews that hold the oil cooler support to the oil cooler transfer housing. Tighten the capscrews. Torque Value: 47 [35 ft-lb] Install the connection retainer and o-ring adapters with new o-rings. Do not tighten the four retainer capscrews at this time.
Adapters must be loose so they will align with the transfer tubes. NOTE: Be careful to keep o-rings in place when installing the adapters and retainer. Installation - Oil Cooler Core Lubricate new o-rings with vegetable oil, and install on the oil cooler core transfer tubes.