Cummins — ASSEMBLY

Accessory Drive - Rebuild (09-02) Drive Units N14 Page 9-8 Measure the inside diameter of the drive pulley bore. Drive Pulley Bore I.D. mm in 34.930 MIN 1.3752 34.950 MAX 1.3760 Assembly Use clean 15W-40 oil to lubricate the housing shaft bore. Use Lubriplate T 105 or its equivalent to lubricate the front thrust face on the housing. Install the shaft and the gear. Use Lubriplate T 105 or its equivalent to lubricate the rear thrust face on the housing. Install the clamping washer over the shaft.