Drive Units Accessory Drive - Rebuild (09-02) N14 Page 9-9 With the gear/shaft assembly supported in an arbor press, use a mandrel to install the coupling. Push the coupling until it touches the clamping washer. NOTE: The splined-type coupling must be installed with the relieved area facing the clamping washer. The hub-type coupling must be installed with the drive tangs facing away from the clamping washer. Caution: The capscrew must contain an oil drilling if an air compressor is to be mounted on the engine. Install the washer and the capscrew. Torque Value: 47 [35 ft-lb] Install the straight thread o-ring plugs in the housing. Torque Value:
5 [47 in-lb] Rotate the shaft to check for correct assembly. Measure the drive shaft end clearance at the end of the shaft for accurate measurement. Drive Shaft End Clearance mm in 0.10 MIN 0.004 0.225 MAX 0.009